1. Unscrew here
2.Remove the brake line protective rubber sleeve.
3.Unscrew the brake tubing head here.
4.Unscrew the brake tubing and pull out the tubing.
5.Remove brake line protective rubber sleeve.
6.Pull the brake tubing from this part of the frame.
7.And then pull it out of this hole at the back of the frameBrake tubing.
8.Loosen the rear brake two screws and remove them.
9.After loosening the screw,the complete set of rear brake is removed.
10.Replace the new brake fixed alignment two Screw hole position.
11.Align the two screw holes and screw them on Screw in this position.
12.Replace the new brake hole at the rear of the frame Bit insert and extend to the front.
13.Extend the brake tubing to this hole and Reach out.
14.After extending the tubing extend the tubing to Over here.
15.Put the brake tubing head on the protective rubber sleeve,Screw up to fix.
16.Put the brake tubing head on the protective rubber sleeve,Screw up to fix.
17.Put the brake tubing head on the protective rubber sleeve, Screw up to fix.
